lkml.org 
[lkml]   [2022]   [Jun]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 12/36] serial: pl011: Fill in rs485_supported
Date
Add information on supported serial_rs485 features.

Signed-off-by: Ilpo Järvinen <ilpo.jarvinen@linux.intel.com>
---
drivers/tty/serial/amba-pl011.c | 8 ++++++++
1 file changed, 8 insertions(+)

diff --git a/drivers/tty/serial/amba-pl011.c b/drivers/tty/serial/amba-pl011.c
index 97ef41cb2721..cdc466e89aa8 100644
--- a/drivers/tty/serial/amba-pl011.c
+++ b/drivers/tty/serial/amba-pl011.c
@@ -2751,6 +2751,13 @@ static int pl011_register_port(struct uart_amba_port *uap)
return ret;
}

+static const struct serial_rs485 pl011_rs485_supported = {
+ .flags = SER_RS485_ENABLED | SER_RS485_RTS_ON_SEND | SER_RS485_RTS_AFTER_SEND |
+ SER_RS485_RX_DURING_TX,
+ .delay_rts_before_send = 1,
+ .delay_rts_after_send = 1,
+};
+
static int pl011_probe(struct amba_device *dev, const struct amba_id *id)
{
struct uart_amba_port *uap;
@@ -2777,6 +2784,7 @@ static int pl011_probe(struct amba_device *dev, const struct amba_id *id)
uap->port.irq = dev->irq[0];
uap->port.ops = &amba_pl011_pops;
uap->port.rs485_config = pl011_rs485_config;
+ uap->port.rs485_supported = &pl011_rs485_supported;
snprintf(uap->type, sizeof(uap->type), "PL011 rev%u", amba_rev(dev));

ret = pl011_setup_port(&dev->dev, uap, &dev->res, portnr);
--
2.30.2
\
 
 \ /
  Last update: 2022-06-06 12:10    [W:0.332 / U:0.684 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site