lkml.org 
[lkml]   [2022]   [Jun]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 22/36] serial: Sanitize rs485_struct
From
Date
On 25.06.22 at 22:12, Lukas Wunner wrote:
> On Mon, Jun 06, 2022 at 01:04:19PM +0300, Ilpo Järvinen wrote:
>> - if (rs485->delay_rts_before_send > RS485_MAX_RTS_DELAY) {
>> + if (!port->rs485_supported->delay_rts_before_send) {
>> + if (rs485->delay_rts_before_send) {
>> + dev_warn_ratelimited(port->dev,
>> + "%s (%d): RTS delay before sending not supported\n",
>> + port->name, port->line);
>> + }
>> + rs485->delay_rts_before_send = 0;
>> + } else if (rs485->delay_rts_before_send > RS485_MAX_RTS_DELAY) {
>> rs485->delay_rts_before_send = RS485_MAX_RTS_DELAY;
>> dev_warn_ratelimited(port->dev,
>> "%s (%d): RTS delay before sending clamped to %u ms\n",
>> port->name, port->line, rs485->delay_rts_before_send);
>> }
>
> This series seems to set rs485_supported->delay_rts_before_send to 1
> in all drivers to indicate that a delay is supported.
>
> It would probably be smarter to define it as a maximum, i.e. drivers
> declare the supported maximum delay in their rs485_supported struct
> and the core can use that to clamp the value. Initially, all drivers
> may use RS485_MAX_RTS_DELAY. Some chips only support specific delays
> (multiples of the UART clock or baud clock). We can amend their
> drivers later according to their capabilities.

Agreed.

Regards,
Lino

\
 
 \ /
  Last update: 2022-06-26 14:41    [W:1.744 / U:0.080 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site