Messages in this thread | | | From | Andy Shevchenko <> | Date | Tue, 21 Jun 2022 11:51:16 +0200 | Subject | Re: [PATCH 47/49] regmap-irq: Add get_irq_reg() callback |
| |
On Mon, Jun 20, 2022 at 10:12 PM Aidan MacDonald <aidanmacdonald.0x0@gmail.com> wrote: > > Replace the internal sub_irq_reg() function with a public callback > that drivers can use when they have more complex register layouts. > The default implementation is regmap_irq_get_irq_reg_linear(), used > if the chip doesn't provide its own callback.
...
> + /* > + * While possible that a user-defined get_irq_reg callback might be
->get_irq_reg()
> + * linear enough to support bulk reads, most of the time it won't. > + * Therefore only allow them if the default callback is being used. > + */ > return !map->use_single_read && map->reg_stride == 1 && > - data->irq_reg_stride == 1; > + data->irq_reg_stride == 1 && > + data->get_irq_reg == regmap_irq_get_irq_reg_linear;
If initially this had been as
return _reg_stride && irq_reg_stride && !map->use_single_read;
you would have done less changes by squeezing a new condition just in between the other two. It will preserve the grouping of the checks as well.
> }
...
> + /* > + * Note we can't use get_irq_reg() here because the offsets
->get_irq_reg()
> + * in 'subreg' are *not* interchangeable with indices. > + */
...
> + /* > + * For not_fixed_stride, don't use get_irq_reg().
Ditto.
> + * It would produce an incorrect result. > + */
...
> + reg = chip->main_status + > + (i * map->reg_stride * > + data->irq_reg_stride);
Parentheses are not necessary. And perhaps the last two can be put on a single line.
...
> + /* > + * NOTE: This is for backward compatibility only and will be removed
FIXME ?
> + * when not_fixed_stride is dropped (it's only used by qcom-pm8008). > + */
-- With Best Regards, Andy Shevchenko
| |