lkml.org 
[lkml]   [2022]   [Jun]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    From
    Subject[PATCH 20/49] regmap-irq: Fix inverted handling of unmask registers
    Date
    To me "unmask" suggests that we write 1s to the register when
    an interrupt is enabled. This also makes sense because it's the
    opposite of what the "mask" register does (write 1s to disable
    an interrupt).

    But regmap-irq does the opposite: for a disabled interrupt, it
    writes 1s to "unmask" and 0s to "mask". This is surprising and
    deviates from the usual way mask registers are handled.

    Additionally, mask_invert didn't interact with unmask registers
    properly -- it caused them to be ignored entirely.

    Fix this by making mask and unmask registers orthogonal, using
    the following behavior:

    * Mask registers are written with 1s for disabled interrupts.
    * Unmask registers are written with 1s for enabled interrupts.

    This behavior supports both normal or inverted mask registers
    and separate set/clear registers via different combinations of
    mask_base/unmask_base. The mask_invert flag is made redundant,
    since an inverted mask register can be described more directly
    as an unmask register.

    To cope with existing drivers that rely on the old "backward"
    behavior, check for the broken_mask_unmask flag and swap the
    roles of mask/unmask registers. This is a compatibility measure
    which can be dropped once the drivers are updated to use the
    new, more consistent behavior.

    Signed-off-by: Aidan MacDonald <aidanmacdonald.0x0@gmail.com>
    ---
    drivers/base/regmap/regmap-irq.c | 96 +++++++++++++++++---------------
    include/linux/regmap.h | 7 ++-
    2 files changed, 55 insertions(+), 48 deletions(-)

    diff --git a/drivers/base/regmap/regmap-irq.c b/drivers/base/regmap/regmap-irq.c
    index 875415fc3133..082a2981120c 100644
    --- a/drivers/base/regmap/regmap-irq.c
    +++ b/drivers/base/regmap/regmap-irq.c
    @@ -30,6 +30,9 @@ struct regmap_irq_chip_data {
    int irq;
    int wake_count;

    + unsigned int mask_base;
    + unsigned int unmask_base;
    +
    void *status_reg_buf;
    unsigned int *main_status_buf;
    unsigned int *status_buf;
    @@ -95,7 +98,6 @@ static void regmap_irq_sync_unlock(struct irq_data *data)
    struct regmap *map = d->map;
    int i, j, ret;
    u32 reg;
    - u32 unmask_offset;
    u32 val;

    if (d->chip->runtime_pm) {
    @@ -124,35 +126,23 @@ static void regmap_irq_sync_unlock(struct irq_data *data)
    * suppress pointless writes.
    */
    for (i = 0; i < d->chip->num_regs; i++) {
    - if (!d->chip->mask_base)
    - continue;
    -
    - reg = sub_irq_reg(d, d->chip->mask_base, i);
    - if (d->chip->mask_invert) {
    + if (d->mask_base) {
    + reg = sub_irq_reg(d, d->mask_base, i);
    ret = regmap_irq_update_mask_bits(d, reg,
    - d->mask_buf_def[i], ~d->mask_buf[i]);
    - } else if (d->chip->unmask_base) {
    - /* set mask with mask_base register */
    + d->mask_buf_def[i], d->mask_buf[i]);
    + if (ret != 0)
    + dev_err(d->map->dev, "Failed to sync masks in %x\n",
    + reg);
    + }
    +
    + if (d->unmask_base) {
    + reg = sub_irq_reg(d, d->unmask_base, i);
    ret = regmap_irq_update_mask_bits(d, reg,
    d->mask_buf_def[i], ~d->mask_buf[i]);
    - if (ret < 0)
    - dev_err(d->map->dev,
    - "Failed to sync unmasks in %x\n",
    + if (ret != 0)
    + dev_err(d->map->dev, "Failed to sync masks in %x\n",
    reg);
    - unmask_offset = d->chip->unmask_base -
    - d->chip->mask_base;
    - /* clear mask with unmask_base register */
    - ret = regmap_irq_update_mask_bits(d,
    - reg + unmask_offset,
    - d->mask_buf_def[i],
    - d->mask_buf[i]);
    - } else {
    - ret = regmap_irq_update_mask_bits(d, reg,
    - d->mask_buf_def[i], d->mask_buf[i]);
    }
    - if (ret != 0)
    - dev_err(d->map->dev, "Failed to sync masks in %x\n",
    - reg);

    reg = sub_irq_reg(d, d->chip->wake_base, i);
    if (d->wake_buf) {
    @@ -634,7 +624,6 @@ int regmap_add_irq_chip_fwnode(struct fwnode_handle *fwnode,
    int i;
    int ret = -ENOMEM;
    u32 reg;
    - u32 unmask_offset;

    if (chip->num_regs <= 0)
    return -EINVAL;
    @@ -732,6 +721,24 @@ int regmap_add_irq_chip_fwnode(struct fwnode_handle *fwnode,
    d->chip = chip;
    d->irq_base = irq_base;

    + /*
    + * Swap role of mask_base and unmask_base if mask bits are inverted.
    + *
    + * Historically, chips that specify both mask_base and unmask_base
    + * got inverted mask behavior; this was arguably a bug in regmap-irq
    + * and there was no way to get the normal, non-inverted behavior.
    + * Those chips will set the broken_mask_unmask flag. They don't set
    + * mask_invert so there is no need to worry about interactions with
    + * that flag.
    + */
    + if (chip->mask_invert || chip->broken_mask_unmask) {
    + d->mask_base = chip->unmask_base;
    + d->unmask_base = chip->mask_base;
    + } else {
    + d->mask_base = chip->mask_base;
    + d->unmask_base = chip->unmask_base;
    + }
    +
    if (chip->irq_reg_stride)
    d->irq_reg_stride = chip->irq_reg_stride;
    else
    @@ -755,28 +762,27 @@ int regmap_add_irq_chip_fwnode(struct fwnode_handle *fwnode,
    /* Mask all the interrupts by default */
    for (i = 0; i < chip->num_regs; i++) {
    d->mask_buf[i] = d->mask_buf_def[i];
    - if (!chip->mask_base)
    - continue;

    - reg = sub_irq_reg(d, d->chip->mask_base, i);
    -
    - if (chip->mask_invert)
    + if (d->mask_base) {
    + reg = sub_irq_reg(d, d->mask_base, i);
    ret = regmap_irq_update_mask_bits(d, reg,
    - d->mask_buf[i], ~d->mask_buf[i]);
    - else if (d->chip->unmask_base) {
    - unmask_offset = d->chip->unmask_base -
    - d->chip->mask_base;
    - ret = regmap_irq_update_mask_bits(d,
    - reg + unmask_offset,
    - d->mask_buf[i],
    - d->mask_buf[i]);
    - } else
    + d->mask_buf_def[i], d->mask_buf[i]);
    + if (ret != 0) {
    + dev_err(map->dev, "Failed to set masks in 0x%x: %d\n",
    + reg, ret);
    + goto err_alloc;
    + }
    + }
    +
    + if (d->unmask_base) {
    + reg = sub_irq_reg(d, d->unmask_base, i);
    ret = regmap_irq_update_mask_bits(d, reg,
    - d->mask_buf[i], d->mask_buf[i]);
    - if (ret != 0) {
    - dev_err(map->dev, "Failed to set masks in 0x%x: %d\n",
    - reg, ret);
    - goto err_alloc;
    + d->mask_buf_def[i], ~d->mask_buf[i]);
    + if (ret != 0) {
    + dev_err(map->dev, "Failed to set masks in 0x%x: %d\n",
    + reg, ret);
    + goto err_alloc;
    + }
    }

    if (!chip->init_ack_masked)
    diff --git a/include/linux/regmap.h b/include/linux/regmap.h
    index 21a70fd99493..0cf3c4a66946 100644
    --- a/include/linux/regmap.h
    +++ b/include/linux/regmap.h
    @@ -1451,10 +1451,11 @@ struct regmap_irq_sub_irq_map {
    * main_status set.
    *
    * @status_base: Base status register address.
    - * @mask_base: Base mask register address.
    + * @mask_base: Base mask register address. Mask bits are set to 1 when an
    + * interrupt is masked, 0 when unmasked.
    * @mask_writeonly: Base mask register is write only.
    - * @unmask_base: Base unmask register address. for chips who have
    - * separate mask and unmask registers
    + * @unmask_base: Base unmask register address. Unmask bits are set to 1 when
    + * an interrupt is unmasked and 0 when masked.
    * @ack_base: Base ack address. If zero then the chip is clear on read.
    * Using zero value is possible with @use_ack bit.
    * @wake_base: Base address for wake enables. If zero unsupported.
    --
    2.35.1
    \
     
     \ /
      Last update: 2022-06-20 22:08    [W:4.183 / U:0.036 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site