Messages in this thread | | | Date | Thu, 27 Feb 2014 22:48:30 +0100 | From | Sebastian Hesselbarth <> | Subject | Re: [PATCH 0/4] ARM: dove: move Dove DT to MVEBU |
| |
On 02/27/2014 10:45 PM, Jason Cooper wrote: > On Thu, Feb 27, 2014 at 10:28:01PM +0100, Sebastian Hesselbarth wrote: >> Thanks to DT conversion effort, Marvell Dove with DT support is now >> ready to leave mach-dove and hop into mach-mvebu. As discussed with >> MVEBU maintainers, we first add dove.c now and keep on migrating >> it with Armada 3xx SoCs the next cycle. >> >> Patch 1 adds a DT node for the system controller found on Marvell >> MVEBU SoCs. >> >> Patch 2 copies an approach taken by Andrew Lunn for Kirkwood-to-MVEBU >> patches, that add MACH_DOVE for Dove in mach-mvebu to distinguish it >> from ARCH_DOVE in mach-dove, where drivers still support both non-DT >> and DT. >> >> Patch 3 then moves mach-dove/board-dt.c to mach-mvebu/dove.c with >> minor cleanups and converts drivers/phy/Kconfig to MACH_DOVE for >> a DT-only driver. >> >> Patch 4 finally adds MACH_DOVE and some of its drivers to multi_v7 >> defconfig. >> >> The patches are based on v3.14-rc4, recently posted mvebu/pinctrl-cleanup >> and mvebu/pinctrl-dove branches: v3.14-rc4 is required for a irqchip >> driver fix when SPARSE_IRQ is set, the pinctrl branches remove hard-coded >> addresses from Dove's pinctrl driver. > > If I were to base this series on v3.14-rc1, I would need to pull in > > mvebu/pinctrl-dove (which draws in mvebu/pinctrl-cleanup) > mvebu/irqchip-fixes > > and that should be all. iiuc, these are boot-time requirements, not > build or merge requirements, correct?
Yes, all are boot-time requirements only.
Sebastian
| |