Messages in this thread | | | Date | Wed, 9 Aug 2023 14:08:10 +0200 | Subject | Re: [PATCH 4/7] arm64: dts: qcom: apq8016-sbc: Rename ov5640 enable-gpios to powerdown-gpios | From | Konrad Dybcio <> |
| |
On 9.08.2023 14:04, Bryan O'Donoghue wrote: > There are two control lines controlled by GPIO going into ov5640 > > - Reset > - Powerdown > > The driver and yaml expect "reset-gpios" and "powerdown-gpios" there has > never been an "enable-gpios". > > Fixes: 39e0ce6cd1bf ("arm64: dts: qcom: apq8016-sbc: Add CCI/Sensor nodes") > Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org> > --- Assuming that the polarity is still correct (maybe the og commiter had different assumptions about what this pin did):
Reviewed-by: Konrad Dybcio <konrad.dybcio@linaro.org>
Konrad
| |