lkml.org 
[lkml]   [2022]   [May]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[RFC 0/2] Add support for multiport controller
Date
Currently the DWC3 driver supports only single port controller which 
requires at most two PHYs ie HS and SS PHYs. There are SoCs that has
DWC3 controller with multiple ports that can operate in host mode. Some of
the port supports both SS+HS and other port supports only HS mode.

This change refactors the PHY logic to support multiport controller. The
patches have gone through basic sanity only.

For any multiport controller we would define a new node "multiport" inside
dwc3 and then add subsequent "mport" nodes inside it for individual ports
that it supports. Now each individual "mport" defines the PHYs that it
supports.

Looking for comments/feedback on the device tree bindings. Once the
bindings are locked, we can further factor the code.

e.g.
Consider a Dual port controller where each port supports HS+SS

multiport {
mp_1: mport@1 {
usb-phys = <usb2_phy0>, <usb3_phy0>;
};
mp_2: mport@2 {
usb-phys = <usb2_phy1>, <usb3_phy1>;
};
};

Harsh Agarwal (2):
dt-bindings: usb: dwc3: Add support for multiport related properties
usb: dwc3: Refactor PHY logic to support Multiport Controller

.../devicetree/bindings/usb/snps,dwc3.yaml | 55 +++++
drivers/usb/dwc3/core.c | 259 ++++++++++++++++-----
drivers/usb/dwc3/core.h | 8 +-
drivers/usb/dwc3/drd.c | 8 +-
drivers/usb/dwc3/gadget.c | 4 +-
5 files changed, 264 insertions(+), 70 deletions(-)

--
2.7.4

\
 
 \ /
  Last update: 2022-05-19 14:36    [W:0.435 / U:0.176 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site