lkml.org 
[lkml]   [2021]   [May]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v3 6/6] leds: Add support for RTL8231 LED scan matrix
On Mon, May 24, 2021 at 1:34 AM Sander Vanheule <sander@svanheule.net> wrote:
>
> Both single and bi-color scanning modes are supported. The driver will
> verify that the addresses are valid for the current mode, before
> registering the LEDs. LEDs can be turned on, off, or toggled at one of
> six predefined rates from 40ms to 1280ms.
>
> Implements a platform device for use as a child device with RTL8231 MFD,
> and uses the parent regmap to access the required registers.

...

> + This options enables support for using the LED scanning matrix output

option

> + of the RTL8231 GPIO and LED expander chip.
> + When built as a module, this module will be named leds-rtl8231.

...

> + interval_ms = 500;

Does this deserve a #define?

...

> + ret = fwnode_property_count_u32(fwnode, "reg");
> + if (ret < 0)
> + return ret;
> + if (ret != 2)
> + return -ENODEV;

I would say -EINVAL, but -ENODEV is similarly okay.

...

> + int err;

ret or err? Be consistent across a single driver.

...

> + int err;

Ditto.


--
With Best Regards,
Andy Shevchenko

\
 
 \ /
  Last update: 2021-05-24 12:25    [W:1.039 / U:0.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site