lkml.org 
[lkml]   [2015]   [Apr]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/4] ARM: at91/dt: sama5d3 xplained: fill in mmc1 and set it to disabled
Date
From: Ben Dooks <ben.dooks@codethink.co.uk>

The mmc1 channel is not populated on the SAM5D3 Xplained board, however
it is enabled and therefore the driver is attaching to it.

The node configuration for mmc1 is missing, so add an mmc1 node in the
device tree and set its status to disabled. Also add the vmmc and the
necessary slot configuration if this node were enabled to avoid the following
warnings from the driver:

atmel_mci f8000000.mmc: No vmmc regulator found
atmel_mci f8000000.mmc: No vqmmc regulator found

Signed-off-by: Ben Dooks <ben.dooks@codethink.co.uk>
Signed-off-by: Ludovic Desroches <ludovic.desroches@atmel.com>
---
arch/arm/boot/dts/at91-sama5d3_xplained.dts | 11 +++++++++++
1 file changed, 11 insertions(+)

diff --git a/arch/arm/boot/dts/at91-sama5d3_xplained.dts b/arch/arm/boot/dts/at91-sama5d3_xplained.dts
index 9991240..af8b263 100644
--- a/arch/arm/boot/dts/at91-sama5d3_xplained.dts
+++ b/arch/arm/boot/dts/at91-sama5d3_xplained.dts
@@ -43,6 +43,17 @@
};
};

+ mmc1: mmc@f8000000 {
+ vmmc-supply = <&vcc_3v3_reg>;
+ vqmmc-supply = <&vcc_3v3_reg>;
+ status = "disabled";
+ slot@0 {
+ reg = <0>;
+ bus-width = <4>;
+ cd-gpios = <&pioE 1 GPIO_ACTIVE_LOW>;
+ };
+ };
+
spi0: spi@f0004000 {
cs-gpios = <&pioD 13 0>, <0>, <0>, <&pioD 16 0>;
status = "okay";
--
2.2.0


\
 
 \ /
  Last update: 2015-04-27 16:01    [W:0.052 / U:0.448 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site