lkml.org 
[lkml]   [2015]   [May]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 1/4] ARM: at91/dt: sama5d3 xplained: fill in mmc1 and set it to disabled
Le 27/04/2015 15:19, Ludovic Desroches a écrit :
> From: Ben Dooks <ben.dooks@codethink.co.uk>
>
> The mmc1 channel is not populated on the SAM5D3 Xplained board, however
> it is enabled and therefore the driver is attaching to it.
>
> The node configuration for mmc1 is missing, so add an mmc1 node in the
> device tree and set its status to disabled. Also add the vmmc and the
> necessary slot configuration if this node were enabled to avoid the following
> warnings from the driver:
>
> atmel_mci f8000000.mmc: No vmmc regulator found
> atmel_mci f8000000.mmc: No vqmmc regulator found
>
> Signed-off-by: Ben Dooks <ben.dooks@codethink.co.uk>
> Signed-off-by: Ludovic Desroches <ludovic.desroches@atmel.com>

Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com>

and queued on at91-4.2-dt branch.

I also sent the update of the at91 defconfigs. We may need to have a
kind of synchronization between them... but a loose one should be okay...

Bye,

> ---
> arch/arm/boot/dts/at91-sama5d3_xplained.dts | 11 +++++++++++
> 1 file changed, 11 insertions(+)
>
> diff --git a/arch/arm/boot/dts/at91-sama5d3_xplained.dts b/arch/arm/boot/dts/at91-sama5d3_xplained.dts
> index 9991240..af8b263 100644
> --- a/arch/arm/boot/dts/at91-sama5d3_xplained.dts
> +++ b/arch/arm/boot/dts/at91-sama5d3_xplained.dts
> @@ -43,6 +43,17 @@
> };
> };
>
> + mmc1: mmc@f8000000 {
> + vmmc-supply = <&vcc_3v3_reg>;
> + vqmmc-supply = <&vcc_3v3_reg>;
> + status = "disabled";
> + slot@0 {
> + reg = <0>;
> + bus-width = <4>;
> + cd-gpios = <&pioE 1 GPIO_ACTIVE_LOW>;
> + };
> + };
> +
> spi0: spi@f0004000 {
> cs-gpios = <&pioD 13 0>, <0>, <0>, <&pioD 16 0>;
> status = "okay";
>


--
Nicolas Ferre


\
 
 \ /
  Last update: 2015-05-19 11:41    [W:0.053 / U:0.112 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site