lkml.org 
[lkml]   [2023]   [Oct]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v13 00/10] Add multiport support for DWC3 controllers
From


On 10/8/2023 4:13 PM, Krzysztof Kozlowski wrote:
> On 07/10/2023 17:47, Krishna Kurapati wrote:
>> Currently the DWC3 driver supports only single port controller which
>> requires at most two PHYs ie HS and SS PHYs. There are SoCs that has
>> DWC3 controller with multiple ports that can operate in host mode.
>> Some of the port supports both SS+HS and other port supports only HS
>> mode.
>>
>> This change primarily refactors the Phy logic in core driver to allow
>> multiport support with Generic Phy's.
>>
>> Changes have been tested on QCOM SoC SA8295P which has 4 ports (2
>> are HS+SS capable and 2 are HS only capable).
>>
>
> I think I said it few times on the lists to Qualcomm folks, although I
> cannot remember whether exactly in this patchset. Please split DTS from
> USB, because Greg prefers to grab everything and DTS *should go* via
> Qualcomm SoC.
>
Hi Krzyztof,

Apologies !

Do you mean to send the DTS just to linux-arm-msm list and not linux-usb
list ? I don't think it was posted on this series and I am not on
linux-arm-msm mailing list, so missed that comment. Sorry for that. I
saw some series where DT, Driver and bindings were sent as one set to
linux-usb list as well and so wanted to follow suite. Will make sure to
send DT just to linux-arm-msm list from now on. Thanks for the comments :-)

Regards,
Krishna,

\
 
 \ /
  Last update: 2023-10-08 19:19    [W:0.659 / U:0.156 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site