lkml.org 
[lkml]   [2022]   [Sep]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v2 0/8] scsi: libsas: sas address comparation refactor
Date
Sas address conversion and comparation is widely used in libsas and
drivers. However they are all opencoded and to avoid the line spill over
80 columns, are mostly split into multi-lines.

To make the code easier to read, introduce some helpers with clearer
semantics and replace the opencoded segments with them.

v1->v2:
First factor out sas_find_attached_phy() and replace LLDDs's code
with it.
Remove three too simple helpers.
Rename the helpers with 'sas_' prefix.

Jason Yan (8):
scsi: libsas: introduce sas_find_attached_phy() helper
scsi: pm8001: use sas_find_attached_phy() instead of open coded
scsi: mvsas: use sas_find_attached_phy() instead of open coded
scsi: hisi_sas: use sas_find_attathed_phy() instead of open coded
scsi: libsas: introduce sas address comparation helpers
scsi: libsas: use sas_phy_match_dev_addr() instead of open coded
scsi: libsas: use sas_phy_addr_same() instead of open coded
scsi: libsas: use sas_phy_match_port_addr() instead of open coded

drivers/scsi/hisi_sas/hisi_sas_main.c | 12 ++------
drivers/scsi/libsas/sas_expander.c | 40 ++++++++++++++++-----------
drivers/scsi/libsas/sas_internal.h | 17 ++++++++++++
drivers/scsi/mvsas/mv_sas.c | 15 +++-------
drivers/scsi/pm8001/pm8001_sas.c | 16 ++++-------
include/scsi/libsas.h | 2 ++
6 files changed, 54 insertions(+), 48 deletions(-)

--
2.31.1

\
 
 \ /
  Last update: 2022-09-24 09:25    [W:0.094 / U:0.068 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site