lkml.org 
[lkml]   [2022]   [Jun]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/2] dt-bindings: net: wireless: ath11k: add new DT entry for board ID
Date
bus + qmi-chip-id + qmi-board-id and optionally the variant are currently
used for identifying the correct board data file.

This however is sometimes not enough as all of the IPQ8074 boards that I
have access to dont have the qmi-board-id properly fused and simply return
the default value of 0xFF.

So, to provide the correct qmi-board-id add a new DT property that allows
the qmi-board-id to be overridden from DTS in cases where its not set.
This is what vendors have been doing in the stock firmwares that were
shipped on boards I have.

Signed-off-by: Robert Marko <robimarko@gmail.com>
---
.../devicetree/bindings/net/wireless/qcom,ath11k.yaml | 8 ++++++++
1 file changed, 8 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/wireless/qcom,ath11k.yaml b/Documentation/devicetree/bindings/net/wireless/qcom,ath11k.yaml
index a677b056f112..fe6aafdab9d4 100644
--- a/Documentation/devicetree/bindings/net/wireless/qcom,ath11k.yaml
+++ b/Documentation/devicetree/bindings/net/wireless/qcom,ath11k.yaml
@@ -41,6 +41,14 @@ properties:
* reg
* reg-names

+ qcom,ath11k-board-id:
+ $ref: /schemas/types.yaml#/definitions/uint32
+ description:
+ Board ID to override the one returned by the firmware or the default
+ 0xff if it was not set by the vendor at all.
+ It is used along the ath11k-calibration-variant to mach the correct
+ calibration data from board-2.bin.
+
qcom,ath11k-calibration-variant:
$ref: /schemas/types.yaml#/definitions/string
description:
--
2.36.1
\
 
 \ /
  Last update: 2022-06-21 15:55    [W:0.121 / U:0.844 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site