lkml.org 
[lkml]   [2022]   [May]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH 0/3] Refresh device tree and defconfig for Ingenic SoCs and boards.
Date
1.Add PWM node for X1830 SoC from Ingenic.
2.Add SSI nodes for X1000 SoC and X1830 SoC from Ingenic.
3.Refresh SSI related nodes in CU1000-Neo and CU1830-Neo.
4.The X1830 SoC used by the CU1830-Neo and the X1000 SoC
used by the CU1000-Neo are both single-core processors,
therefore the "OST_CLK_PERCPU_TIMER" ABI should not be
used in the OST nodes of the CU1830-Neo and CU1000-Neo,
it is just a coincidence that there is no problem now.
So replace the misused "OST_CLK_PERCPU_TIMER" ABI with
the correct "OST_CLK_EVENT_TIMER" ABI.
5.Refresh the defconfig files of the CU1000-Neo board and
the CU1830-Neo board, remove the selection of SPI-GPIO,
and add the selection of SSI.

周琰杰 (Zhou Yanjie) (3):
MIPS: Ingenic: Add PWM nodes for X1830.
MIPS: Ingenic: Refresh device tree for Ingenic SoCs and boards.
MIPS: Ingenic: Refresh defconfig for CU1000-Neo and CU1830-Neo.

arch/mips/boot/dts/ingenic/cu1000-neo.dts | 77 ++++++++++++++++---------------
arch/mips/boot/dts/ingenic/cu1830-neo.dts | 76 +++++++++++++++---------------
arch/mips/boot/dts/ingenic/x1000.dtsi | 20 ++++++++
arch/mips/boot/dts/ingenic/x1830.dtsi | 53 +++++++++++++++++++++
arch/mips/configs/cu1000-neo_defconfig | 2 +-
arch/mips/configs/cu1830-neo_defconfig | 2 +-
6 files changed, 154 insertions(+), 76 deletions(-)

--
2.7.4

\
 
 \ /
  Last update: 2022-05-12 21:35    [W:0.057 / U:0.540 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site