lkml.org 
[lkml]   [2022]   [Nov]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 03/10] arm64: dts: qcom: Add pm8010 pmic dtsi
From
On 16/11/2022 11:31, Abel Vesa wrote:
> From: Neil Armstrong <neil.armstrong@linaro.org>
>
> Add nodes for pm8010 in separate dtsi file.
>
> Signed-off-by: Neil Armstrong <neil.armstrong@linaro.org>
> ---
> arch/arm64/boot/dts/qcom/pm8010.dtsi | 84 ++++++++++++++++++++++++++++
> 1 file changed, 84 insertions(+)
> create mode 100644 arch/arm64/boot/dts/qcom/pm8010.dtsi
>
> diff --git a/arch/arm64/boot/dts/qcom/pm8010.dtsi b/arch/arm64/boot/dts/qcom/pm8010.dtsi
> new file mode 100644
> index 000000000000..0ea641e12209
> --- /dev/null
> +++ b/arch/arm64/boot/dts/qcom/pm8010.dtsi
> @@ -0,0 +1,84 @@
> +// SPDX-License-Identifier: BSD-3-Clause

Any reason why this is licensed BSD-3 clause? It's not a recommended
license (2 clause is). Same for other patches.

> +/*
> + * Copyright (c) 2022, Linaro Limited
> + */
> +
> +#include <dt-bindings/interrupt-controller/irq.h>
> +#include <dt-bindings/spmi/spmi.h>
> +
> +/ {
> + thermal-zones {
> + pm8010-m-thermal {
> + polling-delay-passive = <100>;
> + polling-delay = <0>;
> +
> + thermal-sensors = <&pm8010_m_temp_alarm>;
> +
> + trips {
> + trip0 {
> + temperature = <95000>;
> + hysteresis = <0>;
> + type = "passive";
> + };
> +
> + trip1 {
> + temperature = <115000>;
> + hysteresis = <0>;
> + type = "hot";
> + };
> + };
> + };
> +
> + pm8010-n-thermal {
> + polling-delay-passive = <100>;
> + polling-delay = <0>;
> +
> + thermal-sensors = <&pm8010_n_temp_alarm>;
> +
> + trips {
> + trip0 {
> + temperature = <95000>;
> + hysteresis = <0>;
> + type = "passive";
> + };
> +
> + trip1 {
> + temperature = <115000>;
> + hysteresis = <0>;
> + type = "hot";
> + };
> + };
> + };
> + };
> +};
> +
> +

Just one blank line.


Best regards,
Krzysztof

\
 
 \ /
  Last update: 2022-11-17 13:53    [W:1.032 / U:0.388 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site