lkml.org 
[lkml]   [2022]   [Nov]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v2 2/2] ASoC: codecs: wsa883x: Use proper shutdown GPIO polarity
From


On 10/11/2022 13:35, Krzysztof Kozlowski wrote:
> The shutdown GPIO is active low (SD_N), but this depends on actual board
> layout. Linux drivers should only care about logical state, where high
> (1) means shutdown and low (0) means do not shutdown.
>
> Invert the GPIO to match logical value.
>
> Fixes: 43b8c7dc85a1 ("ASoC: codecs: add wsa883x amplifier support")
> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
>
> ---

Reviewed-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>

>
> Changes since v1:
> 1. None.
> ---
> sound/soc/codecs/wsa883x.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/sound/soc/codecs/wsa883x.c b/sound/soc/codecs/wsa883x.c
> index c7b10bbfba7e..77a7dd3cf495 100644
> --- a/sound/soc/codecs/wsa883x.c
> +++ b/sound/soc/codecs/wsa883x.c
> @@ -1392,7 +1392,7 @@ static int wsa883x_probe(struct sdw_slave *pdev,
> }
>
> wsa883x->sd_n = devm_gpiod_get_optional(&pdev->dev, "powerdown",
> - GPIOD_FLAGS_BIT_NONEXCLUSIVE);
> + GPIOD_FLAGS_BIT_NONEXCLUSIVE | GPIOD_OUT_HIGH);
> if (IS_ERR(wsa883x->sd_n)) {
> dev_err(&pdev->dev, "Shutdown Control GPIO not found\n");
> ret = PTR_ERR(wsa883x->sd_n);
> @@ -1411,7 +1411,7 @@ static int wsa883x_probe(struct sdw_slave *pdev,
> pdev->prop.simple_clk_stop_capable = true;
> pdev->prop.sink_dpn_prop = wsa_sink_dpn_prop;
> pdev->prop.scp_int1_mask = SDW_SCP_INT1_BUS_CLASH | SDW_SCP_INT1_PARITY;
> - gpiod_direction_output(wsa883x->sd_n, 1);
> + gpiod_direction_output(wsa883x->sd_n, 0);
>
> wsa883x->regmap = devm_regmap_init_sdw(pdev, &wsa883x_regmap_config);
> if (IS_ERR(wsa883x->regmap)) {

\
 
 \ /
  Last update: 2022-11-11 17:42    [W:0.048 / U:0.500 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site