lkml.org 
[lkml]   [2022]   [Nov]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 2/2] ASoC: codecs: wsa883x: Use proper shutdown GPIO polarity
Date
The shutdown GPIO is active low (SD_N), but this depends on actual board
layout. Linux drivers should only care about logical state, where high
(1) means shutdown and low (0) means do not shutdown.

Invert the GPIO to match logical value.

Fixes: 43b8c7dc85a1 ("ASoC: codecs: add wsa883x amplifier support")
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>

---

Changes since v1:
1. None.
---
sound/soc/codecs/wsa883x.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/sound/soc/codecs/wsa883x.c b/sound/soc/codecs/wsa883x.c
index c7b10bbfba7e..77a7dd3cf495 100644
--- a/sound/soc/codecs/wsa883x.c
+++ b/sound/soc/codecs/wsa883x.c
@@ -1392,7 +1392,7 @@ static int wsa883x_probe(struct sdw_slave *pdev,
}

wsa883x->sd_n = devm_gpiod_get_optional(&pdev->dev, "powerdown",
- GPIOD_FLAGS_BIT_NONEXCLUSIVE);
+ GPIOD_FLAGS_BIT_NONEXCLUSIVE | GPIOD_OUT_HIGH);
if (IS_ERR(wsa883x->sd_n)) {
dev_err(&pdev->dev, "Shutdown Control GPIO not found\n");
ret = PTR_ERR(wsa883x->sd_n);
@@ -1411,7 +1411,7 @@ static int wsa883x_probe(struct sdw_slave *pdev,
pdev->prop.simple_clk_stop_capable = true;
pdev->prop.sink_dpn_prop = wsa_sink_dpn_prop;
pdev->prop.scp_int1_mask = SDW_SCP_INT1_BUS_CLASH | SDW_SCP_INT1_PARITY;
- gpiod_direction_output(wsa883x->sd_n, 1);
+ gpiod_direction_output(wsa883x->sd_n, 0);

wsa883x->regmap = devm_regmap_init_sdw(pdev, &wsa883x_regmap_config);
if (IS_ERR(wsa883x->regmap)) {
--
2.34.1
\
 
 \ /
  Last update: 2022-11-10 14:36    [W:0.040 / U:0.640 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site