Messages in this thread | | | From | mani@kernel ... | Subject | [PATCH v2 0/6] Add Stinger96 and IoT Box board support | Date | Sun, 3 May 2020 21:12:09 +0530 |
| |
From: Manivannan Sadhasivam <mani@kernel.org>
Hello,
This series adds Stinger96 and IoT Box board support. These boards are based on STM32MP157A SoC, designed and manufactured by Shiratech solutions.
The Stinger96 is a base board (96Boards IoT Extended edition) while IoT Box adds one mezzanine on top of it and sold as a gateway device.
This series depends on below patchsets already submitted and gone through reviews:
[PATCH v3 0/3] Add Reset and Wakeup support for CCS811 [PATCH v3 0/2] Add CTS/RTS gpio support to STM32 UART
More information about these boards can be found in below links:
https://www.shiratech-solutions.com/products/stinger96/ https://www.shiratech-solutions.com/products/iot-box/
Thanks, Mani
Changes in v2:
* Used "stm32" prefix for all DT commits * Dropped custom sdmmc2 pinctrl node since existing node itself has pullup enabled and works fine.
Manivannan Sadhasivam (6): dt-bindings: Add vendor prefix for Shiratech Solutions ARM: dts: stm32: Add missing pinctrl entries for STM32MP15 dt-bindings: arm: stm32: Document Stinger96 compatible ARM: dts: stm32: Add Stinger96 board support dt-bindings: arm: stm32: Document IoT Box compatible ARM: dts: stm32: Add IoT Box board support
.../devicetree/bindings/arm/stm32/stm32.yaml | 2 + .../devicetree/bindings/vendor-prefixes.yaml | 2 + arch/arm/boot/dts/Makefile | 2 + arch/arm/boot/dts/stm32mp15-pinctrl.dtsi | 64 ++++ arch/arm/boot/dts/stm32mp157a-iot-box.dts | 68 ++++ arch/arm/boot/dts/stm32mp157a-stinger96.dts | 12 + arch/arm/boot/dts/stm32mp157a-stinger96.dtsi | 342 ++++++++++++++++++ 7 files changed, 492 insertions(+) create mode 100644 arch/arm/boot/dts/stm32mp157a-iot-box.dts create mode 100644 arch/arm/boot/dts/stm32mp157a-stinger96.dts create mode 100644 arch/arm/boot/dts/stm32mp157a-stinger96.dtsi
-- 2.17.1
| |