lkml.org 
[lkml]   [2020]   [Dec]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH 0/6] v3u: add & update (H)SCIF nodes
Date
SCIF0 already worked because of firmware settings, but let's have a
proper node for it. Also add HSCIF0 because the last patch shows that it
also works. Because these blocks work in general, let's add the other
instances to the DTSI, too.

These additions make me a bit wonder about the 'reg'-based sorting in
our DTSI files. It looks a bit messy to me, but I kept it for
consistency. Same with the (H)SCIF reg sizes which are a tad too large
but in sync with our other DTSI files.

Looking forward to comments!

All the best,

Wolfram


Linh Phung (1):
arm64: dts: renesas: r8a779a0: Add HSCIF support

Wolfram Sang (5):
arm64: dts: renesas: r8a779a0: add & update SCIF nodes
arm64: dts: renesas: falcon: add SCIF0 nodes
dt-bindings: serial: renesas,hscif: Add r8a779a0 support
clk: renesas: r8a779a0: add HSCIF support
WIP: arm64: dts: renesas: falcon: switch to from SCIF0 to HSCIF0

.../bindings/serial/renesas,hscif.yaml | 1 +
.../boot/dts/renesas/r8a779a0-falcon.dts | 31 ++++-
arch/arm64/boot/dts/renesas/r8a779a0.dtsi | 114 ++++++++++++++++++
drivers/clk/renesas/r8a779a0-cpg-mssr.c | 4 +
4 files changed, 149 insertions(+), 1 deletion(-)

--
2.29.2

\
 
 \ /
  Last update: 2020-12-28 12:29    [W:0.124 / U:2.752 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site