Messages in this thread | | | Subject | Re: [PATCH v5 0/4] DCMI BT656 parallel bus mode support | From | Alexandre Torgue <> | Date | Mon, 9 Nov 2020 12:16:08 +0100 |
| |
Hi Hugues
On 11/4/20 6:32 PM, Hugues Fruchet wrote: > Add support of BT656 embedded synchronization bus. > This mode allows to save hardware synchro lines hsync & vsync > by replacing them with synchro codes embedded in data stream. > Add "bus-type" property and make it required so that there is no > ambiguity between parallel mode (bus-type=5) and BT656 mode (bus-type=6). > > =========== > = history = > =========== > version 5: > - Add revisited bindings and devicetree with explicit use of "bus-type" > > version 4: > - Fix typo in commit message > > version 3: > - Fix bus_width print to %u as per Sakari comment > > version 2: > - As per Sakari remark, revisit commit message and document > BT656 parallel bus mode in bindings > > version 1: > - Initial submission > > Hugues Fruchet (4): > media: stm32-dcmi: add support of BT656 bus > media: dt-bindings: media: st,stm32-dcmi: add support of BT656 bus > ARM: dts: stm32: set bus-type in DCMI endpoint for stm32mp157c-ev1 > board > ARM: dts: stm32: set bus-type in DCMI endpoint for stm32429i-eval > board > > .../devicetree/bindings/media/st,stm32-dcmi.yaml | 38 ++++++++++++++++++++++ > arch/arm/boot/dts/stm32429i-eval.dts | 1 + > arch/arm/boot/dts/stm32mp157c-ev1.dts | 1 + > drivers/media/platform/stm32/stm32-dcmi.c | 37 +++++++++++++++++++-- > 4 files changed, 75 insertions(+), 2 deletions(-) >
DT patches applied on stm32-next.
Cheers Alex
| |