Messages in this thread | | | Date | Thu, 02 Aug 2018 11:30:53 -0700 (PDT) | Subject | Re: Finish the GENERIC_IRQ_MULTI_HANDLER conversion | From | Palmer Dabbelt <> |
| |
On Sun, 24 Jun 2018 06:15:25 PDT (-0700), tglx@linutronix.de wrote: > On Thu, 21 Jun 2018, Palmer Dabbelt wrote: >> A while ago I sent a patch set that adds a GENERIC_IRQ_MULTI_HANDLER, >> which is an exact copy of the existing IRQ_MULTI_HANDLER support in the >> arm port, which is being used unconditionally by arm64 and openrisc. >> GENERIC_IRQ_MULTI_HANDLER is currently being used by the RISC-V port. I >> managed to make a few mistakes in my original patch set and as a result >> my conversion of the other architectures of GENERIC_IRQ_MULTI_HANDLER >> was dropped. >> >> This patch set finishes up my original patch set by converting arm, >> arm64, and openrisc over to the new GENERIC_IRQ_MULTI_HANDLER support >> and then removing MULTI_IRQ_HANDLER as it's obselete. >> >> At the time I wrote this I gave it fairly extensive build testing, but >> went I recently rebased it I just tested the full patch set on arm, >> arm64, and openrisc defconfigs. >> >> Various flavors of this patch set have bounced around a few times >> before, but I'm calling this a whole new patch set as it builds on top >> of what was merged. > > I'll take the whole pile through tip irq/core which probably makes the most > sense unless there are any objections from architecture maintainers.
Thanks! Unless I've managed to screw something up I don't see these in your tree, but I also don't see any feedback from anyone else.
| |