Messages in this thread | | | Date | Sun, 24 Jun 2018 15:15:25 +0200 (CEST) | From | Thomas Gleixner <> | Subject | Re: Finish the GENERIC_IRQ_MULTI_HANDLER conversion |
| |
On Thu, 21 Jun 2018, Palmer Dabbelt wrote: > A while ago I sent a patch set that adds a GENERIC_IRQ_MULTI_HANDLER, > which is an exact copy of the existing IRQ_MULTI_HANDLER support in the > arm port, which is being used unconditionally by arm64 and openrisc. > GENERIC_IRQ_MULTI_HANDLER is currently being used by the RISC-V port. I > managed to make a few mistakes in my original patch set and as a result > my conversion of the other architectures of GENERIC_IRQ_MULTI_HANDLER > was dropped. > > This patch set finishes up my original patch set by converting arm, > arm64, and openrisc over to the new GENERIC_IRQ_MULTI_HANDLER support > and then removing MULTI_IRQ_HANDLER as it's obselete. > > At the time I wrote this I gave it fairly extensive build testing, but > went I recently rebased it I just tested the full patch set on arm, > arm64, and openrisc defconfigs. > > Various flavors of this patch set have bounced around a few times > before, but I'm calling this a whole new patch set as it builds on top > of what was merged.
I'll take the whole pile through tip irq/core which probably makes the most sense unless there are any objections from architecture maintainers.
Thanks,
tglx
| |