lkml.org 
[lkml]   [2018]   [Jun]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v10 5/7] i2c: fsi: Add transfer implementation
On Wed, Jun 13, 2018 at 02:36:17PM -0500, Eddie James wrote:
> Execute I2C transfers from the FSI-attached I2C master. Use polling
> instead of interrupts as we have no hardware IRQ over FSI.
>
> Signed-off-by: Eddie James <eajames@linux.vnet.ibm.com>
> ---
> drivers/i2c/busses/i2c-fsi.c | 195 ++++++++++++++++++++++++++++++++++++++++++-
> 1 file changed, 193 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/i2c/busses/i2c-fsi.c b/drivers/i2c/busses/i2c-fsi.c
> index 4611a0b..8c0a6cb 100644
> --- a/drivers/i2c/busses/i2c-fsi.c
> +++ b/drivers/i2c/busses/i2c-fsi.c
> @@ -155,6 +155,7 @@ struct fsi_i2c_port {
> struct i2c_adapter adapter;
> struct fsi_i2c_master *master;
> u16 port;
> + u16 xfrd;
> };
>
> static int fsi_i2c_read_reg(struct fsi_device *fsi, unsigned int reg,
> @@ -230,6 +231,99 @@ static int fsi_i2c_set_port(struct fsi_i2c_port *port)
> return fsi_i2c_write_reg(fsi, I2C_FSI_RESET_ERR, &dummy);
> }
>
> +static int fsi_i2c_start(struct fsi_i2c_port *port, struct i2c_msg *msg,
> + bool stop)
> +{
> + struct fsi_i2c_master *i2c = port->master;
> + u32 cmd = I2C_CMD_WITH_START | I2C_CMD_WITH_ADDR;
> +
> + port->xfrd = 0;
> +
> + if (msg->flags & I2C_M_RD)
> + cmd |= I2C_CMD_READ;

Since you support MANGLING, I'd think you can easily support
I2C_M_REV_DIR_ADDR here, too?

\
 
 \ /
  Last update: 2018-06-26 04:38    [W:0.168 / U:0.976 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site