lkml.org 
[lkml]   [2015]   [Jun]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH 0/8] regulator: pwm-regulator: Introduce continuous-mode
Date
Continuous mode uses the PWM regulator's maximum and minimum supplied
voltages specified in the regulator-{min,max}-microvolt properties to
calculate appropriate duty-cycle values. This allows for a much more
fine grained solution when compared with voltage-table mode, which
this driver already supports. This solution does make an assumption
that a %50 duty-cycle value will cause the regulator voltage to run
at half way between the supplied max_uV and min_uV values.

Lee Jones (8):
ARM: STi: STiH407: Add PWM Regulator node
regulator: pwm-regulator: Remove unnecessary descriptor attribute from ddata
regulator: pwm-regulator: Remove superfluous is_enabled check
regulator: pwm-regulator: Diffientiate between dev (device) and rdev (regulator_dev)
regulator: pwm-regulator: Don't assign structure attributes right away
regulator: pwm-regulator: Separate voltage-table initialisation
regulator: pwm-regulator: Add support for continuous-voltage
regulator: pwm-regulator: Re-write bindings

.../bindings/regulator/pwm-regulator.txt | 66 ++++--
arch/arm/boot/dts/stih407-family.dtsi | 11 +
drivers/regulator/pwm-regulator.c | 222 +++++++++++++++------
3 files changed, 229 insertions(+), 70 deletions(-)

--
1.9.1



\
 
 \ /
  Last update: 2015-06-05 21:01    [W:1.460 / U:0.648 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site