lkml.org 
[lkml]   [2015]   [Oct]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/3] DT binding: gpio-zynq: Document interrupt-controller
Date
HW and driver support the GPIO as interrupt-controller. Document that in
the DT binding.

Signed-off-by: Soren Brinkmann <soren.brinkmann@xilinx.com>
---
Documentation/devicetree/bindings/gpio/gpio-zynq.txt | 9 +++++++++
1 file changed, 9 insertions(+)

diff --git a/Documentation/devicetree/bindings/gpio/gpio-zynq.txt b/Documentation/devicetree/bindings/gpio/gpio-zynq.txt
index db4c6a663c03..7b542657f259 100644
--- a/Documentation/devicetree/bindings/gpio/gpio-zynq.txt
+++ b/Documentation/devicetree/bindings/gpio/gpio-zynq.txt
@@ -12,6 +12,13 @@ Required properties:
- interrupts : Interrupt specifier (see interrupt bindings for
details)
- interrupt-parent : Must be core interrupt controller
+- interrupt-controller : Marks the device node as an interrupt controller.
+- #interrupt-cells : Should be 2. The first cell is the GPIO number.
+ The second cell bits[3:0] is used to specify trigger type and level flags:
+ 1 = low-to-high edge triggered.
+ 2 = high-to-low edge triggered.
+ 4 = active high level-sensitive.
+ 8 = active low level-sensitive.
- reg : Address and length of the register set for the device

Example:
@@ -22,5 +29,7 @@ Example:
gpio-controller;
interrupt-parent = <&intc>;
interrupts = <0 20 4>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
reg = <0xe000a000 0x1000>;
};
--
2.6.2.3.ga463a5b


\
 
 \ /
  Last update: 2015-10-23 19:01    [W:0.169 / U:0.020 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site