Messages in this thread | | | From | Grygorii Strashko <> | Subject | [PATCH v2 0/2] net: davinci_mdio: reuse for keystone2 arch | Date | Wed, 16 Jul 2014 15:13:01 +0300 |
| |
The similar MDIO HW blocks is used by keystone 2 SoCs as in Davinci SoCs: - one in Gigabit Ethernet (GbE) Switch Subsystem See http://www.ti.com/lit/ug/sprugv9d/sprugv9d.pdf - one in 10 Gigabit Ethernet Subsystem See http://www.ti.com/lit/ug/spruhj5/spruhj5.pdf
Hence, reuse Davinci MDIO driver for Keystone 2 and enable TI networking for Keystone 2 devices.
Also, as part of this series, enable PHY's creation from DT, because Keystone 2 supports DT boot mode only.
Changes in v2: - review comments applied. Keystone 2 compatibility string changed to "ti,keystone_mdio".
Grygorii Strashko (2): net: davinci_mdio: reuse for keystone2 arch net: davinci_mdio: allow to create phys from dt
.../devicetree/bindings/net/davinci-mdio.txt | 8 ++++---- drivers/net/ethernet/ti/Kconfig | 4 ++-- drivers/net/ethernet/ti/davinci_mdio.c | 21 ++++++++++++++++++-- 3 files changed, 25 insertions(+), 8 deletions(-)
-- 1.7.9.5
| |