lkml.org 
[lkml]   [2014]   [May]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v2 4/4] ARM: debug: qcom: add UART addresses to Kconfig help
From
2014-05-23 17:12 GMT+02:00 Georgi Djakov <gdjakov@mm-sol.com>:
> Add information about the APQ8084 debug UART physical and virtual
> addresses in the DEBUG_QCOM_UARTDM Kconfig help section.
> Requires: https://lkml.org/lkml/2014/4/14/312
>
> Signed-off-by: Georgi Djakov <gdjakov@mm-sol.com>
> ---
> arch/arm/Kconfig.debug | 1 +
> 1 file changed, 1 insertion(+)
>
> diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
> index 40ee328..e71723d 100644
> --- a/arch/arm/Kconfig.debug
> +++ b/arch/arm/Kconfig.debug
> @@ -376,6 +376,7 @@ choice
> their output to the serial port on Qualcomm devices.
>
> ARCH DEBUG_UART_PHYS DEBUG_UART_BASE
> + APQ8084 0xf995e000 0xfa75e000
> MSM8X60 0x19c40000 0xf0040000
> MSM8960 0x16440000 0xf0040000
> MSM8974 0xf991e000 0xfa71e000

You don't have any uart defined in your dts. You should add them
before any adding low level debug support.
Otherwise there might be problems in booting a multi-platform kernel.

Regards,
Matthias

> --
> 1.7.9.5
>
>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel



--
motzblog.wordpress.com


\
 
 \ /
  Last update: 2014-05-23 19:21    [W:0.079 / U:0.284 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site