Messages in this thread Patch in this message | | | From | Tony Lindgren <> | Subject | [PATCH v2 3/3] bus: ti-sysc: Configure uart quirks for k3 SoC | Date | Wed, 9 Aug 2023 12:27:22 +0300 |
| |
Enable the uart quirks similar to the earlier SoCs. Let's assume we are likely going to need a k3 specific quirk mask separate from the earlier SoCs, so let's not start changing the revision register mask at this point.
Note that SYSC_QUIRK_LEGACY_IDLE will be needed until we can remove the need for pm_runtime_irq_safe() from 8250_omap driver.
Signed-off-by: Tony Lindgren <tony@atomide.com> --- drivers/bus/ti-sysc.c | 2 ++ 1 file changed, 2 insertions(+)
diff --git a/drivers/bus/ti-sysc.c b/drivers/bus/ti-sysc.c --- a/drivers/bus/ti-sysc.c +++ b/drivers/bus/ti-sysc.c @@ -1525,6 +1525,8 @@ static const struct sysc_revision_quirk sysc_revision_quirks[] = { SYSC_QUIRK_SWSUP_SIDLE | SYSC_QUIRK_LEGACY_IDLE), SYSC_QUIRK("uart", 0, 0x50, 0x54, 0x58, 0x47422e03, 0xffffffff, SYSC_QUIRK_SWSUP_SIDLE | SYSC_QUIRK_LEGACY_IDLE), + SYSC_QUIRK("uart", 0, 0x50, 0x54, 0x58, 0x47424e03, 0xffffffff, + SYSC_QUIRK_SWSUP_SIDLE | SYSC_QUIRK_LEGACY_IDLE), /* Quirks that need to be set based on the module address */ SYSC_QUIRK("mcpdm", 0x40132000, 0, 0x10, -ENODEV, 0x50000800, 0xffffffff, -- 2.41.0
| |