lkml.org 
[lkml]   [2023]   [Aug]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] hwmon: (pmbus/bel-pfe) Enable PMBUS_SKIP_STATUS_CHECK for pfe1100
On 8/3/23 16:55, rentao.bupt@gmail.com wrote:
> From: Tao Ren <rentao.bupt@gmail.com>
>
> Enable PMBUS_SKIP_STATUS_CHECK flag for both pfe1100 and pfe3000 because
> the similar communication error is observed on pfe1100 devices.
>
> Signed-off-by: Tao Ren <rentao.bupt@gmail.com>
> ---
> drivers/hwmon/pmbus/bel-pfe.c | 6 +++---
> 1 file changed, 3 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/hwmon/pmbus/bel-pfe.c b/drivers/hwmon/pmbus/bel-pfe.c
> index fa5070ae26bc..8280d274da3f 100644
> --- a/drivers/hwmon/pmbus/bel-pfe.c
> +++ b/drivers/hwmon/pmbus/bel-pfe.c
> @@ -17,12 +17,12 @@
> enum chips {pfe1100, pfe3000};
>
> /*
> - * Disable status check for pfe3000 devices, because some devices report
> + * Disable status check for pfexxxx devices, because some devices report
> * communication error (invalid command) for VOUT_MODE command (0x20)
> * although correct VOUT_MODE (0x16) is returned: it leads to incorrect
> * exponent in linear mode.
> */

Rephrase to something like

Disable status check because some devices ... linear mode.
This affects both pfe3000 and pfe1100.

We don't know if other pfe devices will be supported by the driver in the
future, and we don't know if those will be affected, so we should not make
any claims about such devices.

> -static struct pmbus_platform_data pfe3000_plat_data = {
> +static struct pmbus_platform_data pfe_plat_data = {
> .flags = PMBUS_SKIP_STATUS_CHECK,
> };
>
> @@ -94,6 +94,7 @@ static int pfe_pmbus_probe(struct i2c_client *client)
> int model;
>
> model = (int)i2c_match_id(pfe_device_id, client)->driver_data;
> + client->dev.platform_data = &pfe_plat_data;
>
> /*
> * PFE3000-12-069RA devices may not stay in page 0 during device
> @@ -101,7 +102,6 @@ static int pfe_pmbus_probe(struct i2c_client *client)
> * So let's set the device to page 0 at the beginning.
> */
> if (model == pfe3000) {
> - client->dev.platform_data = &pfe3000_plat_data;
> i2c_smbus_write_byte_data(client, PMBUS_PAGE, 0);
> }
>

{ } is no longer needed.

Thanks,
Guenter

\
 
 \ /
  Last update: 2023-08-04 17:20    [W:0.025 / U:0.524 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site