lkml.org 
[lkml]   [2023]   [Aug]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 2/3] dt-bindings: gnss: u-blox: add "reset-gpios" binding
Date
Needed to enable this chip on a Renesas KingFisher board. Description
copied over from the Mediatek driver which already supports it.

Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
---

Changes since v1:
* dropped obvious description (Thanks, Geert!)
* added missing include (Thanks, Krzysztof and Rob!)

I build tested the change this time.

Documentation/devicetree/bindings/gnss/u-blox,neo-6m.yaml | 5 +++++
1 file changed, 5 insertions(+)

diff --git a/Documentation/devicetree/bindings/gnss/u-blox,neo-6m.yaml b/Documentation/devicetree/bindings/gnss/u-blox,neo-6m.yaml
index 4835a280b3bf..8e97e475613f 100644
--- a/Documentation/devicetree/bindings/gnss/u-blox,neo-6m.yaml
+++ b/Documentation/devicetree/bindings/gnss/u-blox,neo-6m.yaml
@@ -41,6 +41,9 @@ properties:
description: >
Backup voltage regulator

+ reset-gpios:
+ maxItems: 1
+
required:
- compatible
- vcc-supply
@@ -49,10 +52,12 @@ unevaluatedProperties: false

examples:
- |
+ #include <dt-bindings/gpio/gpio.h>
serial {
gnss {
compatible = "u-blox,neo-8";
v-bckp-supply = <&gnss_v_bckp_reg>;
vcc-supply = <&gnss_vcc_reg>;
+ reset-gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
};
};
--
2.35.1
\
 
 \ /
  Last update: 2023-08-16 19:33    [W:0.048 / U:0.904 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site