lkml.org 
[lkml]   [2023]   [Jul]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 2/2] led: led-class: Read max-brightness from devicetree
Date
Normally, the maximum brightness is determined by the hardware, and this
property is not required. This property is used to set a software limit.
It could happen that an LED is made so bright that it gets damaged or
causes damage due to restrictions in a specific system, such as mounting
conditions.
Note that this flag is mainly used for PWM-LEDs, where it is not possible
to map brightness to current. Drivers for other controllers should use
led-max-microamp.

Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: Astrid Rost <astrid.rost@axis.com>
---
drivers/leds/led-class.c | 4 ++++
1 file changed, 4 insertions(+)

diff --git a/drivers/leds/led-class.c b/drivers/leds/led-class.c
index 9255bc11f99d..ce652abf9336 100644
--- a/drivers/leds/led-class.c
+++ b/drivers/leds/led-class.c
@@ -457,6 +457,10 @@ int led_classdev_register_ext(struct device *parent,
if (fwnode_property_present(init_data->fwnode,
"retain-state-shutdown"))
led_cdev->flags |= LED_RETAIN_AT_SHUTDOWN;
+
+ fwnode_property_read_u32(init_data->fwnode,
+ "max-brightness",
+ &led_cdev->max_brightness);
}
} else {
proposed_name = led_cdev->name;
--
2.30.2
\
 
 \ /
  Last update: 2023-07-03 15:03    [W:0.025 / U:2.196 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site