lkml.org 
[lkml]   [2023]   [Jul]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v2] net: netsec: Ignore 'phy-mode' on SynQuacer in DT mode
From
On 7/28/23 15:51, Mark Brown wrote:
> As documented in acd7aaf51b20 ("netsec: ignore 'phy-mode' device
> property on ACPI systems") the SocioNext SynQuacer platform ships with
> firmware defining the PHY mode as RGMII even though the physical
> configuration of the PHY is for TX and RX commits.

Did you mean to write "delays" instead of "commits" here?

> Since
> bbc4d71d63549bc ("net: phy: realtek: fix rtl8211e rx/tx delay config")
> this has caused misconfiguration of the PHY, rendering the network
> unusable.
>
> This was worked around for ACPI by ignoring the phy-mode property but
> the system is also used with DT. For DT instead if we're running on a
> SynQuacer force a working PHY mode, as well as the standard EDK2
> firmware with DT there are also some of these systems that use u-boot
> and might not initialise the PHY if not netbooting. Newer firmware
> imagaes for at least EDK2 are available from Linaro so print a warning
> when doing this.
>
> Fixes: 533dd11a12f6 ("net: socionext: Add Synquacer NetSec driver")
> Signed-off-by: Mark Brown <broonie@kernel.org>
--
Florian

\
 
 \ /
  Last update: 2023-07-29 00:55    [W:0.040 / U:0.324 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site