Messages in this thread | | | Date | Sun, 7 May 2023 18:46:19 +0300 | Subject | Re: [PATCH RESEND v3 3/5] iio: adc: qcom-spmi-adc5: Fall back to datasheet_name instead of fwnode name | From | Dmitry Baryshkov <> |
| |
On 02/05/2023 02:17, Marijn Suijten wrote: > Since the migration to fwnode_get_name in commit 4f47a236a23d ("iio: > adc: qcom-spmi-adc5: convert to device properties") the resulting > adc5_channel_prop::channel_name (renamed from datasheet_name in the > previous patch) - which is propagated into iio_chan_spec::extend_name - > was containing the DT node name including @xx suffix if a "label" > property is not present, while adc5_channels::datasheet_name was thus > far set by the macros but always remained unread. Put it to use instead > of using a confusing name containing @xx in sysfs filenames (again, when > "label" is not set). > > Signed-off-by: Marijn Suijten <marijn.suijten@somainline.org> > --- > drivers/iio/adc/qcom-spmi-adc5.c | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-)
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
-- With best wishes Dmitry
| |