Messages in this thread | | | Date | Sun, 7 May 2023 18:45:46 +0300 | Subject | Re: [PATCH RESEND v3 2/5] iio: adc: qcom-spmi-adc5: Use driver datasheet_name instead of DT label | From | Dmitry Baryshkov <> |
| |
On 02/05/2023 02:17, Marijn Suijten wrote: > iio_chan_spec::datasheet_name expects a channel/pin name on the hardware > part, i.e. from its datasheet, instead of a friendly name from DT which > typically describes the use of said channel. GPIO channels are commonly > specialized in QCOM board DTS based on what a - typically thermistor - > is connected to. > > Also rename adc5_channel_prop::datasheet_name to channel_name to that > effect. > > Signed-off-by: Marijn Suijten <marijn.suijten@somainline.org> > --- > drivers/iio/adc/qcom-spmi-adc5.c | 10 +++++----- > 1 file changed, 5 insertions(+), 5 deletions(-)
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
-- With best wishes Dmitry
| |