lkml.org 
[lkml]   [2023]   [May]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 1/4] spi: dt-bindings: Introduce spi-mosi-idle-low flag
Date
Some spi controller switch the mosi line to high, whenever they are
idle. This may not be desired in all use cases. For example neopixel
leds can get confused and flicker due to misinterpreting the idle state.
Therefore, we introduce a new spi-mode bit, with which the idle behaviour
can be overwritten on a per device basis.

Signed-off-by: Boerge Struempfel <bstruempfel@ultratronik.de>
---
.../devicetree/bindings/spi/spi-peripheral-props.yaml | 6 ++++++
1 file changed, 6 insertions(+)

diff --git a/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml b/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml
index 782a014b63a76..46d5acc1fc232 100644
--- a/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml
+++ b/Documentation/devicetree/bindings/spi/spi-peripheral-props.yaml
@@ -34,6 +34,12 @@ properties:
description:
The device requires the chip select active high.

+ spi-mosi-idle-low:
+ $ref: /schemas/types.yaml#/definitions/flag
+ description:
+ The device requires the mosi line to be low when idle and the
+ chip select is asserted.
+
spi-lsb-first:
$ref: /schemas/types.yaml#/definitions/flag
description:
--
2.25.1
\
 
 \ /
  Last update: 2023-05-12 01:15    [W:0.138 / U:0.324 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site