Messages in this thread | | | Date | Wed, 12 Apr 2023 20:06:28 +0300 | Subject | Re: Aw: Re: Re: Re: Re: Re: [PATCH v3 0/5] arm: dts: mt7623: relocate gmacs, mt7530 switch, and add | From | Arınç ÜNAL <> |
| |
On 12.04.2023 19:53, Frank Wunderlich wrote: > Hi > >> Gesendet: Mittwoch, 12. April 2023 um 18:21 Uhr >> Von: "Arınç ÜNAL" <arinc.unal@arinc9.com> >>> thanks, it changes the master when i upgrade iproute to 6.1 (from debian bullseye-backports), but i cannot do any traffic on it after switching to gmac1... >>> >>> 5: wan@eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP group default qlen 1000 >>> link/ether f2:d2:51:56:cd:3d brd ff:ff:ff:ff:ff:ff >>> inet 192.168.0.11/24 scope global wan >>> valid_lft forever preferred_lft forever >>> >>> see no p5-TX/gmac-rx > >> Did you apply the vlan and flooding fix patches from Richard? > > have now applied all patches i've found from richard (which are all rejected): > > fe4495bb3cc2 2023-02-12 Fix setting up CPU and User ports to be in the correct mode during setup and when toggling vlan_filtering on a bridge port. (HEAD -> 6.3-rc) > b0641f3e1a69 2023-02-12 Fix Flooding: Disable by default on User ports and Enable on CPU ports > cb04b3451524 2023-02-12 Do not add all User ports to the CPU by default. This will break Multi CPU when added a seperate patch. It will be overwritten by .port_enable and since we are forcing output to a port via the Special Tag this is not needed. > > and now it seems working and is clear ;) > > root@bpi-r2:~# ip l show wan > 5: wan@eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP mode DEFAULT group default qlen 1000 > link/ether f2:d2:51:56:cd:3d brd ff:ff:ff:ff:ff:ff > > iperf3 > [ ID] Interval Transfer Bitrate Retr > [ 5] 0.00-10.00 sec 1.09 GBytes 940 Mbits/sec 0 sender > [ 5] 0.00-10.03 sec 1.09 GBytes 936 Mbits/sec receiver > > > iperf3 -R > [ ID] Interval Transfer Bitrate Retr > [ 5] 0.00-10.04 sec 1.09 GBytes 936 Mbits/sec 0 sender > [ 5] 0.00-10.00 sec 1.09 GBytes 938 Mbits/sec receiver > > > how do you deal with these patches? do you include them into your mt7530 fixes series? they (and vladimirs preferred cpu-port) need to be applied before these DTS-changes
Dealing with this is the last step on my tasklist. Take a look:
https://arinc9.notion.site/mt7530-c-improvements-bbfdc2ceb958484b9627297b88bc6d4a
Arınç
| |