lkml.org 
[lkml]   [2023]   [Feb]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: BCM54220: After the BCM54220 closes the auto-negotiation, the configuration forces the 1000M network port to be linked down all the time.
From
On 2/17/23 00:06, Wang, Xiaolei wrote:
> hi
>
>     When I use the nxp-imx7 board, eth0 is connected to the PC, eth0 is
> turned off the auto-negotiation mode, and the configuration is forced to
> 10M, 100M, 1000M. When configured to force 1000M,
>     The link status of phy status reg(0x1) is always 0, and the chip of
> phy is BCM54220, but I did not find the relevant datasheet on BCM
> official website, does anyone have any suggestions or the datasheet of
> BCM54220?

I don't have access to a system with a BCM54220 but can look at the
datasheet, could you provide the full output of mii-diag in both cases?
What do the PC report as far as link partner advertisement goes etc.?

You are using a twister pair cable to connect your two systems?
--
Florian

\
 
 \ /
  Last update: 2023-03-27 00:27    [W:0.044 / U:0.144 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site