lkml.org 
[lkml]   [2023]   [Dec]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH V2] arm64: dts: qcom: qcm6490: Add UFS nodes
From
On 21.12.2023 12:19, Manish Pandey wrote:
> Add UFS host controller and Phy nodes for
> Qualcomm qcm6490 Board.
>
> Signed-off-by: Manish Pandey <quic_mapa@quicinc.com>
> ---
> Changes from v1:
> - updated with correct patchset
Well no, this clearly hasn't been compile-tested..

Please also include the board name in the subject
(qcm6490: -> qcm6490-idp:)
>
> ---
> arch/arm64/boot/dts/qcom/qcm6490-idp.dts | 19 +++++++++++++++++++
> 1 file changed, 19 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/qcom/qcm6490-idp.dts b/arch/arm64/boot/dts/qcom/qcm6490-idp.dts
> index 03e97e27d16d..51efd46b576c 100644
> --- a/arch/arm64/boot/dts/qcom/qcm6490-idp.dts
> +++ b/arch/arm64/boot/dts/qcom/qcm6490-idp.dts
> @@ -440,6 +440,25 @@
> status = "okay";
> };
>
> +&ufs_mem_hc {
> + reset-gpios = <&tlmm 175 GPIO_ACTIVE_LOW>;
> + vcc-supply = <&vreg_l7b_2p9>;
> + vcc-max-microamp = <800000>;
> + vccq-supply = <&vreg_l9b_1p2>;
> + vccq-max-microamp = <900000>;
> + vccq2-supply = <&vreg_l9b_1p2>;
> + vccq2-max-microamp = <900000>;
These regulators should get regulator-allow-set-load since the
UFS driver expects to perform current/mode setting ops on them

Konrad

\
 
 \ /
  Last update: 2023-12-21 15:08    [W:0.031 / U:0.660 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site