Messages in this thread | | | Date | Mon, 20 Nov 2023 11:08:00 +0200 | Subject | Re: [PATCH] ARM: at91: pm: set soc_pm.data.mode in at91_pm_secure_init() | From | claudiu beznea <> |
| |
On 20.10.2023 16:02, thomas.perrot@bootlin.com wrote: > From: Thomas Perrot <thomas.perrot@bootlin.com> > > In non secure mode, soc_pm.data.mode is set when entering pm in > at91_pm_begin(). This value is used (not only) to determine if the system > is going into slow clock mode (at91_suspend_entering_slow_clock()). This > function is called from various drivers to check this and act accordingly. > If not set, the driver might enter an incorrect suspend mode. When using > secure suspend mode, at91_pm_begin() is not called and thus > soc_pm.data.mode is not set. Since when using secure suspend, only one > suspend mode is supported, set this value directly in > at91_pm_secure_init(). > > Signed-off-by: Clément Léger <clement.leger@bootlin.com> > Signed-off-by: Thomas Perrot <thomas.perrot@bootlin.com>
Applied to at91-soc, thanks!
| |