lkml.org 
[lkml]   [2023]   [Nov]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v2 5/9] arm64: dts: ti: k3-am62x-sk: Enable camera peripherals
From
On 11/17/23 3:28 AM, Jai Luthra wrote:
> CSI cameras are controlled using I2C, on SK-AM62 and derivative boards
> this is routed to I2C-2, so enable that bus. Also enable the nodes for
> CSI-RX and DPHY-RX IPs.
>
> Specific sensor connected to this bus will be described in the DT
> overlay for each sensor.
>
> Tested-by: Martyn Welch <martyn.welch@collabora.com>
> Signed-off-by: Jai Luthra <j-luthra@ti.com>
> ---
> arch/arm64/boot/dts/ti/k3-am62x-sk-common.dtsi | 15 +++++++++++++++
> 1 file changed, 15 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/ti/k3-am62x-sk-common.dtsi b/arch/arm64/boot/dts/ti/k3-am62x-sk-common.dtsi
> index 19f57ead4ebd..21658f811307 100644
> --- a/arch/arm64/boot/dts/ti/k3-am62x-sk-common.dtsi
> +++ b/arch/arm64/boot/dts/ti/k3-am62x-sk-common.dtsi
> @@ -399,6 +399,13 @@ sii9022_out: endpoint {
> };
> };
>
> +&main_i2c2 {
> + status = "okay";
> + pinctrl-names = "default";
> + pinctrl-0 = <&main_i2c2_pins_default>;
> + clock-frequency = <400000>;
> +};
> +
> &sdhci0 {
> bootph-all;
> status = "okay";
> @@ -517,3 +524,11 @@ dpi1_out: endpoint {
> };
> };
> };
> +
> +&ti_csi2rx0 {
> + status = "okay";
> +};
> +
> +&dphy0 {
> + status = "okay";
> +};
>

Why do this in the common file? These should go in the overlays
that actually make use of these nodes, same as you did for BeaglePlay
in patch [4/9].

Andrew

\
 
 \ /
  Last update: 2023-11-20 20:33    [W:0.192 / U:0.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site