lkml.org 
[lkml]   [2022]   [May]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] iommu/vt-d: Increase DMAR_UNITS_SUPPORTED
Date
Increase DMAR_UNITS_SUPPORTED to support 64 sockets with 10 DMAR units
each, for a total of 640.

If the available hardware exceeds DMAR_UNITS_SUPPORTED (previously set
to MAX_IO_APICS, or 128), it causes these messages: "DMAR: Failed to
allocate seq_id", "DMAR: Parse DMAR table failure.", and "x2apic: IRQ
remapping doesn't support X2APIC mode x2apic disabled"; and the system
fails to boot.

Signed-off-by: Steve Wahl <steve.wahl@hpe.com>
Reviewed-by: Mike Travis <mike.travis@hpe.com>
---

Note that we could not find a reason for connecting
DMAR_UNITS_SUPPORTED to MAX_IO_APICS as was done previously. Perhaps
it seemed like the two would continue to match on earlier processors.
There doesn't appear to be kernel code that assumes that the value of
one is related to the other.

include/linux/dmar.h | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/include/linux/dmar.h b/include/linux/dmar.h
index 45e903d84733..9d4867b8f42e 100644
--- a/include/linux/dmar.h
+++ b/include/linux/dmar.h
@@ -19,7 +19,7 @@
struct acpi_dmar_header;

#ifdef CONFIG_X86
-# define DMAR_UNITS_SUPPORTED MAX_IO_APICS
+# define DMAR_UNITS_SUPPORTED 640
#else
# define DMAR_UNITS_SUPPORTED 64
#endif
--
2.26.2
\
 
 \ /
  Last update: 2022-05-05 21:49    [W:0.172 / U:0.588 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site