lkml.org 
[lkml]   [2022]   [May]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/2] phy: qcom-qmp: fix pipe-clock imbalance on power-on failure
On 02-05-22, 12:27, Johan Hovold wrote:
> On Mon, May 02, 2022 at 03:39:41PM +0530, Vinod Koul wrote:
> > On 20-04-22, 17:23, Johan Hovold wrote:
> > > Make sure to disable the pipe clock also if ufs-reset deassertion fails
> > > during power on.
> > >
> > > Note that the ufs-reset is asserted in qcom_qmp_phy_com_exit().
> > >
> > > Fixes: c9b589791fc1 ("phy: qcom: Utilize UFS reset controller")
> > > Cc: Evan Green <evgreen@chromium.org>
> > > Signed-off-by: Johan Hovold <johan+linaro@kernel.org>
> > > ---
> > > drivers/phy/qualcomm/phy-qcom-qmp.c | 14 +++++++-------
> > > 1 file changed, 7 insertions(+), 7 deletions(-)
> > >
> > > diff --git a/drivers/phy/qualcomm/phy-qcom-qmp.c b/drivers/phy/qualcomm/phy-qcom-qmp.c
> > > index 8c2300bfe489..7d2d1ab061f7 100644
> > > --- a/drivers/phy/qualcomm/phy-qcom-qmp.c
> > > +++ b/drivers/phy/qualcomm/phy-qcom-qmp.c
> > > @@ -5375,14 +5375,14 @@ static int qcom_qmp_phy_power_on(struct phy *phy)
> > > if (ret) {
> > > dev_err(qmp->dev, "lane%d reset deassert failed\n",
> > > qphy->index);
> > > - goto err_lane_rst;
> > > + return ret;
> >
> > This can be skipped if we retain the err_lane_rst label
> >
> > > }
> > > }
> > >
> > > ret = clk_prepare_enable(qphy->pipe_clk);
> > > if (ret) {
> > > dev_err(qmp->dev, "pipe_clk enable failed err=%d\n", ret);
> > > - goto err_clk_enable;
> > > + goto err_reset_lane;
> > > }
> > >
> > > /* Tx, Rx, and PCS configurations */
> > > @@ -5433,7 +5433,7 @@ static int qcom_qmp_phy_power_on(struct phy *phy)
> > >
> > > ret = reset_control_deassert(qmp->ufs_reset);
> > > if (ret)
> > > - goto err_lane_rst;
> > > + goto err_disable_pipe_clk;
> >
> > this is the actual fix...
>
> Right, but with a one-line fix this would read
>
> goto err_pcs_ready;
>
> which makes no sense at all. Is that really what you prefer?

Yes I feel for a fix we should always have the minimal changes.. makes
porting easier

>
> Renaming just this one and the below one, would leave the error labels
> named using two different schemes, which also isn't very nice, but
> perhaps ok.
>
> > >
> > > qcom_qmp_phy_configure(pcs_misc, cfg->regs, cfg->pcs_misc_tbl,
> > > cfg->pcs_misc_tbl_num);
> > > @@ -5472,17 +5472,17 @@ static int qcom_qmp_phy_power_on(struct phy *phy)
> > > PHY_INIT_COMPLETE_TIMEOUT);
> > > if (ret) {
> > > dev_err(qmp->dev, "phy initialization timed-out\n");
> > > - goto err_pcs_ready;
> > > + goto err_disable_pipe_clk;
> >
> > same rename here
> >
> > > }
> > > }
> > > return 0;
> > >
> > > -err_pcs_ready:
> > > +err_disable_pipe_clk:
> > > clk_disable_unprepare(qphy->pipe_clk);
> > > -err_clk_enable:
> > > +err_reset_lane:
> > > if (cfg->has_lane_rst)
> > > reset_control_assert(qphy->lane_rst);
> > > -err_lane_rst:
> > > +
> > > return ret;
> >
> > while I feel the names given by this patch are better, they should not
> > be in a fix patch. We should just add the one line fix here and do
> > renames later
>
> I'll respin if you prefer, just want to double check that you really
> want a one line fix (i.e. goto err_pcs_ready).

Yes please


--
~Vinod

\
 
 \ /
  Last update: 2022-05-02 14:01    [W:0.037 / U:1.604 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site