lkml.org 
[lkml]   [2022]   [May]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/2] phy: qcom-qmp: fix pipe-clock imbalance on power-on failure
On 20-04-22, 17:23, Johan Hovold wrote:
> Make sure to disable the pipe clock also if ufs-reset deassertion fails
> during power on.
>
> Note that the ufs-reset is asserted in qcom_qmp_phy_com_exit().
>
> Fixes: c9b589791fc1 ("phy: qcom: Utilize UFS reset controller")
> Cc: Evan Green <evgreen@chromium.org>
> Signed-off-by: Johan Hovold <johan+linaro@kernel.org>
> ---
> drivers/phy/qualcomm/phy-qcom-qmp.c | 14 +++++++-------
> 1 file changed, 7 insertions(+), 7 deletions(-)
>
> diff --git a/drivers/phy/qualcomm/phy-qcom-qmp.c b/drivers/phy/qualcomm/phy-qcom-qmp.c
> index 8c2300bfe489..7d2d1ab061f7 100644
> --- a/drivers/phy/qualcomm/phy-qcom-qmp.c
> +++ b/drivers/phy/qualcomm/phy-qcom-qmp.c
> @@ -5375,14 +5375,14 @@ static int qcom_qmp_phy_power_on(struct phy *phy)
> if (ret) {
> dev_err(qmp->dev, "lane%d reset deassert failed\n",
> qphy->index);
> - goto err_lane_rst;
> + return ret;

This can be skipped if we retain the err_lane_rst label

> }
> }
>
> ret = clk_prepare_enable(qphy->pipe_clk);
> if (ret) {
> dev_err(qmp->dev, "pipe_clk enable failed err=%d\n", ret);
> - goto err_clk_enable;
> + goto err_reset_lane;
> }
>
> /* Tx, Rx, and PCS configurations */
> @@ -5433,7 +5433,7 @@ static int qcom_qmp_phy_power_on(struct phy *phy)
>
> ret = reset_control_deassert(qmp->ufs_reset);
> if (ret)
> - goto err_lane_rst;
> + goto err_disable_pipe_clk;

this is the actual fix...

>
> qcom_qmp_phy_configure(pcs_misc, cfg->regs, cfg->pcs_misc_tbl,
> cfg->pcs_misc_tbl_num);
> @@ -5472,17 +5472,17 @@ static int qcom_qmp_phy_power_on(struct phy *phy)
> PHY_INIT_COMPLETE_TIMEOUT);
> if (ret) {
> dev_err(qmp->dev, "phy initialization timed-out\n");
> - goto err_pcs_ready;
> + goto err_disable_pipe_clk;

same rename here

> }
> }
> return 0;
>
> -err_pcs_ready:
> +err_disable_pipe_clk:
> clk_disable_unprepare(qphy->pipe_clk);
> -err_clk_enable:
> +err_reset_lane:
> if (cfg->has_lane_rst)
> reset_control_assert(qphy->lane_rst);
> -err_lane_rst:
> +
> return ret;

while I feel the names given by this patch are better, they should not
be in a fix patch. We should just add the one line fix here and do
renames later

> }
>
> --
> 2.35.1

--
~Vinod

\
 
 \ /
  Last update: 2022-05-02 12:11    [W:2.242 / U:0.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site