lkml.org 
[lkml]   [2022]   [Apr]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[V3 3/3] arch: arm64: dts: qcom: Configure cts sleep pinctrl to bias-bus-hold
Date
WLAN rail was leaking power during RBSC/sleep even after turning BT off.
Change sleep pinctrl configuration to handle same.

Signed-off-by: Vijaya Krishna Nivarthi <quic_vnivarth@quicinc.com>
---
v3: apply same change to active state and other sc7280*.dts* as well
v2: used bias-bus-hold as per review comments
v1: intial patch used bias-disable for sleep pinctrl in sc7280-idp only
---
arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi | 13 ++++++++-----
1 file changed, 8 insertions(+), 5 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi b/arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi
index b833ba1..602ebd4 100644
--- a/arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi
+++ b/arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi
@@ -398,8 +398,11 @@ mos_bt_uart: &uart7 {

/* For mos_bt_uart */
&qup_uart7_cts {
- /* Configure a pull-down on CTS to match the pull of the Bluetooth module. */
- bias-pull-down;
+ /*
+ * Configure a bias-bus-hold on CTS to lower power usage
+ * when BT is turned off.
+ */
+ bias-bus-hold;
};

/* For mos_bt_uart */
@@ -490,10 +493,10 @@ mos_bt_uart: &uart7 {
pins = "gpio28";
function = "gpio";
/*
- * Configure a pull-down on CTS to match the pull of
- * the Bluetooth module.
+ * Configure a bias-bus-hold on CTS to lower power usage
+ * when BT is turned off.
*/
- bias-pull-down;
+ bias-bus-hold;
};

/* For mos_bt_uart */
--
Qualcomm INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, hosted by the Linux Foundation.
\
 
 \ /
  Last update: 2022-04-06 13:59    [W:0.091 / U:0.672 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site