lkml.org 
[lkml]   [2022]   [Apr]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v1 0/3] WAR to handle WCN6750 hardware issue
Date
On WCN6750 sometimes observed AON power source takes 100ms
time to fully discharge voltage during OFF. As WCN6750 is
combo chip for WLAN and BT. If any of the tech area ON is
triggered during discharge phase, it fails to turn ON.
To overcome this hardware issue, During BT ON, driver check
for WLAN_EN pin status. If it high, it will pull BT_EN to high
immediately else it will wait for 100ms assuming WLAN was just
powered OFF and then BT_EN will be pulled to high.

Balakrishna Godavarthi (3):
dt-bindings: net: bluetooth: Add wlan-gpio entry for wcn6750
arm64: dts: qcom: sc7280: Add wlan enable gpio to bluetooth node
Bluetooth: hci_qca: WAR to handle WCN6750 HW issue

.../bindings/net/qualcomm-bluetooth.yaml | 6 +++++
arch/arm64/boot/dts/qcom/sc7280-idp.dtsi | 1 +
drivers/bluetooth/hci_qca.c | 30 +++++++++++++++++-----
3 files changed, 31 insertions(+), 6 deletions(-)

--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project

\
 
 \ /
  Last update: 2022-04-29 13:31    [W:0.117 / U:0.396 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site