lkml.org 
[lkml]   [2022]   [Apr]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject[PATCH 1/2] dt-bindings: net: dsa: marvell: Add single-chip-address property
Some Marvell DSA devices can be accessed in a single chip addressing
mode. This is currently configured by setting the address of the switch
to 0. However switches in this configuration do not respond to address
0, only responding to higher addresses (fixed addressed based on the
switch model) for the individual ports/etc. This is a feature to allow
for other phys to exist on the same mdio bus.

This change defines a 'single-chip-address' property in order to
explicitly define that the chip is accessed in this mode. This allows
for a switch to have an address defined other than 0, so that address
0 can be used for another mdio device.

Signed-off-by: Nathan Rossi <nathan@nathanrossi.com>
---
Documentation/devicetree/bindings/net/dsa/marvell.txt | 2 ++
1 file changed, 2 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/dsa/marvell.txt b/Documentation/devicetree/bindings/net/dsa/marvell.txt
index 2363b41241..5c7304274c 100644
--- a/Documentation/devicetree/bindings/net/dsa/marvell.txt
+++ b/Documentation/devicetree/bindings/net/dsa/marvell.txt
@@ -46,6 +46,8 @@ Optional properties:
- mdio? : Container of PHYs and devices on the external MDIO
bus. The node must contains a compatible string of
"marvell,mv88e6xxx-mdio-external"
+- single-chip-address : Device is configured to use single chip addressing
+ mode.

Example:

---
2.35.2
\
 
 \ /
  Last update: 2022-04-23 15:15    [W:0.073 / U:0.080 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site