lkml.org 
[lkml]   [2022]   [Dec]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC PATCH 07/14] usb: host: xhci: Add XHCI secondary interrupter support
On 24.12.2022 1.31, Wesley Cheng wrote:
> Implement the XHCI operations for allocating and requesting for a secondary
> interrupter. The secondary interrupter can allow for events for a
> particular endpoint to be routed to a separate event ring. The event
> routing is defined when submitting a transfer descriptor to the USB HW.
> There is a specific field which denotes which interrupter ring to route the
> event to when the transfer is completed.
>
> An example use case, such as audio packet offloading can utilize a separate
> event ring, so that these events can be routed to a different processor
> within the system. The processor would be able to independently submit
> transfers and handle its completions without intervention from the main
> processor.
>

Adding support for more xHCI interrupters than just the primary one make sense for
both the offloading and virtualization cases.

xHCI support for several interrupters was probably added to support virtualization,
to hand over usb devices to virtual machines and give them their own event ring and
MSI/MSI-X vector.

In this offloading case you probably want to avoid xHC interrupts from this device
completely, making sure it doesn't wake up the main CPU unnecessarily.

So is the idea here to let xhci driver set up the new interrupter, its event ring,
and the endpoint transfer rings. Then pass the address of the endpoint transfer rings
and the new event ring to the separate processor.

This separate processor then both polls the event ring for new events, sets its dequeue
pointer, clears EHB bit, and queues new TRBs on the transfer ring.

so xhci driver does not handle any events for the audio part, and no audio data URBs
are sent to usb core?

How about the control part?
Is the control endpoint for this device still handled normally by usb core/xhci?

For the xhci parts I think we should start start by adding generic support for several
interrupters, then add parts needed for offloading.

Thanks
Mathias

\
 
 \ /
  Last update: 2023-03-26 23:22    [W:0.525 / U:0.100 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site