Messages in this thread | | | From | Rob Herring <> | Subject | Re: [PATCH v2] dt-bindings: iio: dac: Change the I2C slave address for ds4422/4424 to its correct value | Date | Tue, 11 Oct 2022 08:10:04 -0500 |
| |
On Wed, 12 Oct 2022 13:14:46 +0530, Rajat Khandelwal wrote: > The datasheet states that the slave address for the device is 0x20 > when the pins A0 and A1 are ground. The DT binding has been using > 0x10 as the value and I think it should be 0x20 as per datasheet. > > Signed-off-by: Rajat Khandelwal <rajat.khandelwal@linux.intel.com> > --- > > v2: > 1. Subject prefix added > 2. DT bindings validated > > Documentation/devicetree/bindings/iio/dac/maxim,ds4424.yaml | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) >
My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check' on your patch (DT_CHECKER_FLAGS is new in v5.13):
yamllint warnings/errors:
dtschema/dtc warnings/errors: Documentation/devicetree/bindings/iio/dac/maxim,ds4424.example.dts:22.20-26.15: Warning (i2c_bus_reg): /example-0/i2c/dac@10: I2C bus unit address format error, expected "20"
doc reference errors (make refcheckdocs):
See https://patchwork.ozlabs.org/patch/
This check can fail if there are any dependencies. The base for a patch series is generally the most recent rc1.
If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date:
pip3 install dtschema --upgrade
Please check and re-submit.
| |