lkml.org 
[lkml]   [2022]   [Jan]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2] selftests: rtc: Increase test timeout so that all tests run
From
Date
On 1/12/22 1:22 PM, Alexandre Belloni wrote:
> On 12/01/2022 14:41:42-0500, Nícolas F. R. A. Prado wrote:
>> The timeout setting for the rtc kselftest is currently 90 seconds. This
>> setting is used by the kselftest runner to stop running a test if it
>> takes longer than the assigned value.
>>
>> However, two of the test cases inside rtc set alarms. These alarms are
>> set to the next beginning of the minute, so each of these test cases may
>> take up to, in the worst case, 60 seconds.
>>
>> In order to allow for all test cases in rtc to run, even in the worst
>> case, when using the kselftest runner, the timeout value should be
>> increased to at least 120. Set it to 180, so there's some additional
>> slack.
>>
>> Correct operation can be tested by running the following command right
>> after the start of a minute (low second count), and checking that all
>> test cases run:
>>
>> ./run_kselftest.sh -c rtc
>>
>> Signed-off-by: Nícolas F. R. A. Prado <nfraprado@collabora.com>
> Acked-by: Alexandre Belloni <alexandre.belloni@bootlin.com>

Thank you both. Will apply this for 5.17-rc2 once the merge window
closes.

thanks,
-- Shuah

\
 
 \ /
  Last update: 2022-01-13 00:52    [W:0.056 / U:1.500 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site