lkml.org 
[lkml]   [2022]   [Jan]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2] selftests: rtc: Increase test timeout so that all tests run
From
Date
On 1/12/22 4:51 PM, Shuah Khan wrote:
> On 1/12/22 1:22 PM, Alexandre Belloni wrote:
>> On 12/01/2022 14:41:42-0500, Nícolas F. R. A. Prado wrote:
>>> The timeout setting for the rtc kselftest is currently 90 seconds. This
>>> setting is used by the kselftest runner to stop running a test if it
>>> takes longer than the assigned value.
>>>
>>> However, two of the test cases inside rtc set alarms. These alarms are
>>> set to the next beginning of the minute, so each of these test cases may
>>> take up to, in the worst case, 60 seconds.
>>>
>>> In order to allow for all test cases in rtc to run, even in the worst
>>> case, when using the kselftest runner, the timeout value should be
>>> increased to at least 120. Set it to 180, so there's some additional
>>> slack.
>>>
>>> Correct operation can be tested by running the following command right
>>> after the start of a minute (low second count), and checking that all
>>> test cases run:
>>>
>>>     ./run_kselftest.sh -c rtc
>>>
>>> Signed-off-by: Nícolas F. R. A. Prado <nfraprado@collabora.com>
>> Acked-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
>
> Thank you both. Will apply this for 5.17-rc2 once the merge window
> closes.
>

Applied to linux-kselftest fixes branch for rc2/rc3

thanks,
-- Shuah

\
 
 \ /
  Last update: 2022-01-25 21:54    [W:0.320 / U:0.004 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site